IMPREZA U.S.A. (E)
10-44
Aluminum wheels (if equipped)
Aluminum wheels can be scratched and damaged easily. Handle them
carefully to maintain their appearance, performance, and safety.
D When any of the wheels is removed and replaced for tire rotation or to
change a flat, always check the tightness of the wheel nuts after driving
approximately 600 miles (1,000 km). If any nut is loose, tighten it to the
specified torque.
D Never apply oil to the threaded parts, wheel nuts, or tapered surface
of the wheel.
D Never let the wheel rub against sharp protrusions or curbs.
D Be sure to fit tire chains on uniformly and completely around the tire,
otherwise the chains may scratch the wheel.
D When wheel nuts, balance weights, or the center cap are replaced,
be sure to replace them with genuine SUBARU parts designed for alumi-
num wheels.
Fuses
HG0127HS0202
The fuses are designed to melt during an overload to prevent damage to
the wiring harness and electrical equipment. The fuses are located in
two fuse boxes.
If any lights, accessories or other electrical controls do not operate, in-
spect the corresponding fuse. If a fuse has blown, replace it.
To Next Page
Loading...
Need help?
General
