Black plate (135,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
& High/low beam change (dim-
mer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “
” on the instru-
ment panel is also on.
To switch back to low beam, pull the lever
back to the detent position.
& Headlight flasher
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the lighting switch is in the
“OFF” position.
When the headlights are on high beam,
the high beam indicator light “
” on the
instrument panel also comes on.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
& Daytime running light system
! Canada-spec. 2.5XT
WARNING
The parking lights, and side marker
lights are not turned on by the
daytime running light system. The
light switch must always be turned
to the “
” position when it is dark
outside.
The low beam headlights and tail lights will
automatically come on when the engine
has started, under the following condi-
tions:
. The parking brake is fully released.
. The light switch is in the “OFF” or “
”
position.
. The automatic transmission selector
lever is set at other than the “P” position.
! All models except Canada-spec.
2.5XT
WARNING
The tail lights, parking lights, and
side marker lights are not turned on
by the daytime running light system.
The ligh t switch mus t always be
turned to the “
” position when it
Instruments and controls 3-21
– CONTINUED –
3
To Next Page
Loading...
Need help?
General
