Black plate (338,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
11-48 Maintenance and service
& Headlights (Vehicle with HID
headlights)
WARNING
High-intensity-discharge (HID) bulbs
are used for the low beams of the
headlights on the Canada-spec.
2.5XT. These HID bulbs use an
extremely high voltage. To avoid
the risk of an electric shock and
resulting serious injury, you should
not attempt to replace them. Neither
should you attempt to replace the
high-beam bulbs, remove/refit the
headlight assemblies, or remove
any headlight-assembly compo-
nents. For replacement of the head-
light bulbs (low-beam and high-
beam), removal and installation of
the headlight assemblies, and re-
moval of headlight-assembly com-
ponents, contact your SUBARU
dealer.
& Headlights (Vehicle without
HID headlights)
CAUTION
Halogen headlight bulbs b ecome
very hot while in use. If you touch
the bulb surface with bare hands or
greasy gloves , finger prints or
grease on the bulb surface will
develop into hot spots and cause
the bulb to break. If there are finger
prints or grease on the bulb surface,
wipe them away with a soft cloth
moistened with alcohol.
NOTE
. If headlight aiming is required, con-
sult your SUBARU dealer for proper
adjustment of the headlight aim.
. It may be difficult to replace the
bulbs. Have your SUBARU dealer re-
place the bulbs if necessary.
Before replacing the left-hand (battery-
side) low- or high-beam light bulb, remove
the screw that retains the windshield
washer nozzle and tip the windshield
washer nozzle sideways.
! Low beam light bulbs
1. Remove the bulb cover, by turning it
counterclockwise.
To Next Page
Loading...
Need help?
General
