Black plate (222,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
7-14 Starting and operating
steep grade.
In this position, the transmission holds in
the 2nd gear.
Use this position when starting off from a
standstill on slippery road surfaces such
as mud or snow. It will ensure greater
traction.
! 1 (First)
This position is for driving up or down very
steep grades, or driving through mud or
sand, or on slippery surfaces. In this
position, the transmission holds in the
1st gear.
! Maximum speeds
WARNING
When shifting down a gear, ensure
that the vehicle is not travelling at a
speed exceeding the Maximum Al-
lowable Speed for the gear which is
about to be selected. Failure to
observe this precaution can lead to
engine over-revving and this in turn
can result in engine damage.
In addition, sudden application of
engine brakes when the vehicle is
travelling on a slippery surface can
lead to wheel locking; as a conse-
quence, control of the vehicle may
be lost and the risk of an accident
increased.
The following tables show the maximum
speeds that are possible with each differ-
ent gear.
When shifting down a gear, it is important
to confirm that the current vehicle speed is
not in excess of the Maximum Allowable
Speed of the gear which is about to be
selected.
mph (km/h)
Non-turbo
models
Turbo models
1st 28 (45) 23 (37)
2nd 63 (100) 65 (104)
3rd 98 (156)
104 (167)
NOTE
In order to prevent over-revving during
deceleration of the vehicle, the trans-
mission will remain in the current gear
if the speed of the vehicle is in excess
of the Maximum Allowable Speed for
the gear to which the selector lever has
been moved.
! Driving tips
. Always apply the foot or parking brake
when the vehicle is stopped in the “D”, “3”,
“2”, “1” or “R ” position.
. Always set the parking brake when
parking your vehicle. Do not hold the
vehicle with only the transmission.
. Do not keep the vehicle in a stationary
position on an uphill grade by using the
“D”, “3”, “2”,or“1” position. Use the brake
instead.
& Shift lock release
If the selector lever does not move from
the “ P” position with the brake pedal
depressed and the ignition switch in the
“ON” position, perform the following steps:
To override the shift lock:
1. Set the parking brake and stop the
engine.
2. Take out the screwdriver.
3. Remove the cover by prying on the
edge with the screwdriver.
To Next Page
Loading...
Need help?
General
