Sungrow Logger3000 User Manual

51
DDaattaa
TTyyppee
DDaattaaIIDD
SSttaattee
IInnvveerrtt
CCooeeffffiiccii--
eenntt
UUiinntt DDaattaa
NNaammee
YK 6 Y N 1 NA Power On
/ Off
YT 7 Y N 1 kW
P-Set
YT 8 Y N 1 Var
Q-Set
table 9-3 Parameter
PPaarraammeetteerr VVaalluuee
DDeessccrriippttiioonn
Data Type
-
Data type
Data ID
-
Data type
State* Y
Data is uploaded to the background via the
IEC104 communication protocol
N
Data is not uploaded to the background
Invert* Y
Negate, 0 is 1, and 1 is 0, available for
telesignalling only
N
No negate, 0 is 0 and 1 is 1
Coefficient*
-
Coefficient, available for telemetry, remote
pulse, and remote regulating only
Uint
-
Unit, available for telemetry, remote pulse,
and remote regulating only
NA indicates no unit
Data Name
-
Data name in multiple languages
Note: * indicates that the parameters should be set according to onsite conditions.
step 5 Open the sheet "Device List" of the IEC104 forwarding point table to sort the devices.
PPaarraammeetteerr DDeessccrriippttiioonn
No. Sort devices, and only support moving the whole line for the
device type corresponds one-to-one to its parameters in the
same line
Device Type Device type
Com ID* Number of COM port to which device connected,
corresponding to the port data of the "Device list" on the
Web interface
Collect ID* Collect device Modbus address, corresponding to
communication address of the "Device list" on the Web
interface
User Manual 9 Web Interface

Sungrow Logger3000 Specifications

General

Brand	Sungrow
Model	Logger3000
Category	Data Loggers
Language	English