63
10.2.1.6 Country Mode
If the dispatching input must be the national power dispatching instruction, the active
control mode is set to "Country mode".
step 1 Click "Power control" -> "Active power" to enter the active power interface.
step 2 Set the active control mode to "Country mode".
step 3 Select a country and PPC type, and click "Save".
When the country is set to "Korea", corresponding parameter description is as follows:
table 10-5 Parameter description
PPaarraammeetteerr DDeessccrriippttiioonn
PPC type PPC device of DER-AVM type
When the country is set to "Japan", corresponding parameter description is as follows:
table 10-6 Parameter description
PPaarraammeetteerr
DDeessccrriippttiioonn
Scheduling mode
Logger3000 is connected to the power plant dispatch server
designated by the Japan Electric Power Company to realize
the Kyushu power dispatch.
Obtaining Schedule
Support remote download and local import
When it is set to "Remote download", fill in plant code and
server address, and import certificate, to download schedule
from the set server address.
When it is set to "Local import", just import the schedule file.
Parameter type
Select "Plant parameter" or "Device parameter".
When selecting "Plant parameter", set plant capacity and PV
module capacity further.
When selecting "Device parameter", click "Detailed device
parameter" to view and set device information.
Time calibration
Calibrate the time as needed. Calibration range: -10~10.
When the system time of Logger3000 < the time adjusted
after "Time calibration", or the time of Logger1000 < the NTP
synchronization time,
The time validity will be displayed as "Invalid", at which time
Logger1000 will send a stop instruction to the inverter.
"Time validity: Invalid" will not disappear until the "Time
calibration" or NTP synchronization operation is performed.
-- -- EEnndd
User Manual 10 Grid Dispatching
To Next Page
Loading...
Need help?
General
