16 GSF1200AK6/SAK6 (’06-MODEL)
ABS CONTROL UNIT/HU
• Never allow dust or water to contact the ABS control unit/HU.
• Never subject the ABS control unit/HU to strong impacts or
allow them to be dropped.
• The ABS control unit/HU cannot be disassembled. Replace
the whole unit with a new one.
ABS INFORMATION
#
• Be sure to route the brake hoses correctly.
• The ABS does not shorten the motorcycle’s braking distance.
When riding down slopes or on wet or bumpy roads the brak-
ing distance is lengthened as compared to a motorcycle with-
out ABS. In addition, braking distance increases the more
slippery the road is.
• The ABS does not control slides which may occur when brak-
ing while turning. As with a motorcycle that does not have
ABS, it is best not apply the brakes while turning.
• The brake levers may move by themselves when they are
applied. This is not a malfunction.
• Only use the specified tires.
Incorrect
Incorrect
Incorrect
* Be sure to bleed air from the brake fluid circuit when
the brake feel is spongy or when a brake relating part
is replaced.
* Never ride the motorcycle before bleeding the air.
SAMPLE
To Next Page
Need help?
General
