2-6
IGNITION SWITCH
To open the ignition key-hole shutter:
1. Match the ignition key head to the
square hole on the ignition switch.
2. Turn the key to open and close the
key-hole shutter.
NOTE: Apply anti-freeze lubricant
when atmospheric temperature drops
below freezing to avoid ignition key-
hole shutter freezing.
Immobilizer equipped model
“OFF” Position
All electrical circuits are cut off. The
engine will not start. The key can be
removed.
“ON” Position
The ignition circuit is completed and
the engine can now be started. The
key cannot be removed from the igni-
tion switch.
NOTE: Start the engine promptly after
turning the key to the “ON” position,
or the battery will lose power due to
consumption by the headlight and tail-
light.
“LOCK” Position
To lock the steering, turn the handle-
bar all the way to the left. Push the
key in and turn it to the “LOCK” posi-
tion and remove the key. All electrical
circuits are cut off.
“P” (Parking) Position
When parking the motorcycle, lock
the steering and turn the key to the
“P” position. The key can now be
removed and the position light and
taillight will remain lit and the steering
will be locked. This position is for
night time roadside parking to
increase visibility.
To Next Page
Loading...
Need help?
General
