5-2
RIDING TIPS
STARTING THE ENGINE
Before attempting to start the engine,
make sure:
• The transmission is in neutral.
• The engine stop switch is in the
“” position.
NOTE: When the electric starter
switch is pushed, the starter motor
will continue turning for about 1.5 sec-
onds even when you release your
hand from the switch. After elapsing
about 1.5 second, or when the engine
is started, the starter motor will stop
automatically.
NOTE: This motorcycle is equipped
with an interlock system for the igni-
tion circuit and the starter circuit.
The engine can only be started if:
• The transmission is in neutral, or
• The transmission is in gear, the
side stand is fully up and the
clutch is disengaged.
NOTE: The fuel supply system stops
the engine when the motorcycle is
overturned. Turn off the ignition switch
before restarting the engine.
When the Engine is Cold:
1. Close the throttle completely and
push the electric starter switch.
2. After the engine starts, let the
engine run until the engine suffi-
ciently warms up.
When a Cold Engine is Hard to
Start:
1. Open the throttle approximately 1/8
turn and push the electric starter
switch.
2. After the engine starts, let the
engine run until the engine suffi-
ciently warms up.
When the Engine is Warm:
Close the throttle completely and
push the electric starter switch.
When a Warm Engine is Hard to
Start:
Open the throttle approximately 1/8
turn and push the electric starter
switch.