Suzuki GSX1250FA User Manual

6-47
9. Pull the rear wheel assembly rear-
ward.
NOTE: Never depress the rear brake
pedal with the rear wheel removed. It
is very difficult to force the pads back
into the caliper assembly.
10. To replace the wheel reverse the
complete sequence listed.
11. Adjust the drive chain slack.
12. After installing the wheel, apply
the brake several times and then
check that the wheel rotates
freely.
Rear axle nut tightening torque:
100 N·m (10.0 kgf-m, 72.5 lbf-ft)
 WARNING
Failure to adjust the drive chain
and failure to torque bolts and
nuts properly could lead to an
accident.
• After installing the rear wheel,
adjust the drive chain as
described in the DRIVE CHAIN
ADJUSTMENT section.
• Torque bolts and nuts to the
proper specifications. If you are
not sure of the proper proce-
dure, have your authorized
Suzuki dealer or a qualified
mechanic do this.
 WARNING
Failure to extend brake pads after
installing the wheel can cause
poor braking performance and
may result in an accident.
Before riding, “pump” the brake
pedal repeatedly until brake pads
are pressed against the brake
disks and proper pedal stroke and
firm feel are restored. Also check
that the wheel rotates freely.

Suzuki GSX1250FA Specifications

General

Engine Type	4-stroke, liquid-cooled, DOHC
Engine Displacement	1255 cc
Bore x Stroke	79.0 mm x 64.0 mm
Compression Ratio	10.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Starter	Electric
Transmission	6-speed constant mesh
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Disc, twin
Rear Brakes	Disc
Front Tire Size	120/70ZR17M/C (58W), tubeless
Rear Tire Size	180/55ZR17M/C (73W), tubeless
Overall Length	2130 mm
Overall Width	790 mm
Wheelbase	1485 mm
Seat Height	805 mm
Curb Weight	257 kg
Fuel Tank Capacity	19.0 L