6-45
Front axle bolt tightening torque:
100 N·m (10.0 kgf-m, 72.5 lbf-ft)
Front axle holder bolt
tightening torque:
23 N·m (2.3 kgf-m, 16.5 lbf-ft)
Front brake caliper mounting bolt
tightening torque:
25 N·m (2.5 kgf-m, 18.0 lbf-ft)
REAR WHEEL REMOVAL
1. Place the motorcycle on the cen-
ter stand.
2. Remove the rear wheel speed
sensor by removing the mounting
bolts.
CAUTION
A hot muffler can burn you.
Wait until the muffler cools before
removing the axle nut.
NOTICE
Removing the rear wheel without
use of an accessory stand can
result in your motorcycle falling
over and being damaged.
Do not attempt roadside removal
of the rear wheel. Only remove the
rear wheel at a properly equipped
servicing facility using an acces-
sory service stand.
To Next Page
Loading...
Need help?
General
