6-48
LIGHT BULB REPLACEMENT
The wattage rating of each bulb is
shown on the table below. When
replacing a burned out bulb, always
use the exact same wattage rating.
Using other than the specified rating
can result in overloading the electrical
system or premature failure of a bulb.
HEADLIGHT/POSITION LIGHT
To replace the headlight bulb and
position light bulb, perform the follow-
ing step:
Low beam bulb
1. Remove the two bolts 1. Unhook
the hooks.
2. Disconnect the coupler 2 and
remove the instrument panel.
NOTICE
Failure to use a light bulb with the
correct wattage rating can over-
load the electrical system of your
motorcycle or cause the bulb to
burn out sooner.
Use only the light bulbs shown in
the chart as replacement bulbs.
Headlight
12V 55W (H7)
... Low beam
12V 60W (HB3)
... High beam
Turn signal light 12V 21W × 4
Brake light/Taillight 12V 21/5W
Position light 12V 5W × 2
License plate light 12V 5W
To Next Page
Loading...
Need help?
General
