6-41
Be sure to balance the wheel after repairing
a puncture or replacing the tyre. Proper
wheel balance is important to avoid variable
wheel-to-road contact, and to avoid uneven
tyre wear.
LIGHT BULB REPLACEMENT
The wattage rating of each bulb is shown on
the chart below. When replacing a burned
out bulb, always use the exact same wattage
rating. Using other than the specified rating
can result in overloading the electrical sys-
tem or premature failure of a bulb.
WARNING
An improperly repaired, installed, or bal-
anced tyre can cause loss of control or
shorten tyre life.
• Ask your SUZUKI dealer or a qualified
mechanic to perform tyre repair,
replacement, and balancing because
proper tools and experience are
required.
• Install tyres according to the rotation
direction shown by arrows on the side-
wall of each tyre.
CAUTION
Using a light bulb with the wrong watt-
age rating can cause electrical system
damage or shorten bulb life.
Always use the specified light bulb.
Headlight 12V 35/35W (HS1)
Front turn signal light 12V 10W × 2
Rear turn signal light 12V 10W × 2
Brake light/Taillight 12V 21/5W
License plate light 12V 5W
To Next Page
Loading...
Need help?
General
