43
MAINTENANCE AND INSPECTION
09
9.1) CHECK POINTS FOR REGULAR INSPECTION
9.2) CLEANING
Use the air compressor to clean each part of the machine.
9.1.1) Clean, oil, and grease the set parts of the machine on a regular basis.
9.1.2) Inspect tension of each driver belt.
9.1.3) Failure to perform regular inspections can cause the following.
– Corrosion of P/C circuit board
– Damage to the semi-conductor on P/C circuit board
– Malfunction of the floppy disk drive
– Ill connection of the connector
– Abnormal wear-outs of machine parts due to insufficient oiling and greasing
1 Around the hook Every day
①
Major parts for cleaningNo. Cleaning cycle Fig.
Hook
①
Consumable parts shall not be guaranteed even in warranty period.
1) Machine and electricity safety rules must be observed during the inspection.
2) Make sure to turn OFF and STOP the machine when performing inspection.
CAUTION
1) Turn OFF the main power before inspecting or cleaning of the machine.
2) Adjust the cleaning cycle according to the conditions of use and to the environment.
CAUTION
SWF is not responsible for machine damages or malfunction caused by insufficient regular
inspection.
CAUTION
To Next Page
Loading...
Need help?
General
