SWF MAN-12 User Manual

70
11.2) ERROR DISPLAY AND TROUBLESHOOTING
11.2.1) Main shaft motor and others
100
101
102
103
104
105
107
108
109
Main shaft stop
Main shaft motor drive
Main shaft motor overload
Trimming return
START switch
STOP switch
Valve
Air pressure
AC line
Main shaft doesn’t stop at 100°
Error in main shaft motor driver
Thread tangles in the hook
Error in needle bar controller
Thread tangle in trimming
Trimming sensor doesn’t return
when trimming
START is pressed when turning
power on
STOP is pressed when turning
power on
Valve is opened
Air pressure is below standard
(Sequin)
Problems in the joint board
Adjust the main shaft at 100°
using lever.
Turn the main switch off and on
again.
Check hooks of all heads. Turn
the switch off and on again.
Check for errors in the trimming
system
Check START – connector
connection
Check STOP – connector
connection
Replace the joint board, etc.
No. Error Description Troubleshooting
11.2.2) X, Y-axis motors
200
201
202
203
204
205
206
207
(＋X) frame limit
(－X) frame limit
(＋Y) frame limit
(－Y) frame limit
X-axis driver
Y-axis driver
Wiper return
Trimmer return
Frame reaches ＋X limit
Frame reaches －X limit
Frame reaches ＋Y limit
Frame reaches －Y limit
Error in X-axis driver
Error in Y-axis driver
Wiper motor doesn’t return
Trimmer solenoid doesn’t return
Move the frame －X
Move the frame ＋X
Move the frame －Y
Move the frame ＋Y
Turn the main switch off and on
again
Turn the main switch off and on
again
Repair the wiper mechanism
Repair the trimmer mechanism
No. Error Description Troubleshooting

SWF MAN-12 Specifications

General

Brand	SWF
Model	MAN-12
Category	Sewing Machine
Language	English