74
SETTING
12
Turn on the main power
Execute installation program
Call the design
Set up conditions for machine operation
Select needle bar
Repetition work
Set-up work position
Start work with a bar switch
Select frame offset function
Gauge, trace, length
measure
Will you do repetition work?
Will you do auxiliary work (gauge, etc.)?
Will you select frame offset?
Read the design from
disk or tape
Is the previous design in the memory?
Is there an operating program in the memory?
Are F1+F2+F7 keys pressed?
Automatic call of design
Automatic call of set-up values
Is there a previous design?
Yes
No
No
Yes
No
Yes
No
Yes
Yes
No
Yes
Yes
To Previous Page
Loading...
Need help?
General
