www.major-equipment.com
10
1
2
2
3
4
5
4
B
C
D
A
A
B
C
C
D
Castor wheels (optional)
To adjust the height of front wheels lift up the
machine and:
1. Unscrew and remove Bolt A;
2. Slide down the Castor Yoke B and remove
it;
3. Depending on the desired cutting height
place Spacers C above or below Castor
Arm D.
4. When adjusment is complete, relocate
Castor Yoke B and secure it with Bolt A.
5. Repeat this procedure for the other wheel.
Roller
To adjust the height of the roller follow this procedure at
both sides of the roller:
1. Loosen Bolts B and C (Note: You do not have to remove
these bolts, half of the turn will sufce to allow movement);
2. Turn Nut D clockwise to increase the cut height or anti-
clockwise to decrease the cut height;
3. Match the height of the roller on both sides of the machine
by checking the position of Arrow A;
4. When adjustment is complete, re-tighten Bolts B and C.
Scraper bar
Scraper bar is supplied as an optional extra. In order
for a scraper bar to function properly, it should be
kept tensioned. To tension the scraper bar (1) tighten
up nuts (2) at both ends of the roller (3). Locate
the scraper bar bracket (4) in a desired position by
looseing/tightening bracket nut (5).
Roller and Castor wheels adjustment
In order to achieve desired cutting height, castor wheels and roller should be adjusted.
To Next Page
Loading...
Need help?
General