Taylor C706 Operator's Manual

Section 8
8-1
Model C706
Troubleshooting Guide
8
Troubleshooting Guide
Table 8-1
Problem Probable Cause Remedy
Page
Ref.
1. No product is being
dispensed with the draw
valve open and the
machine in the Auto
mode.
a. Freeze-up in mix inlet hole. a. Call a Taylor service technician to
adjust the mix hopper temperature.
- - -
b. Beater motor out on reset. b. Reset the freezer. 5-3
c. The beater is rotating
counterclockwise from the
operator end.
c. Contact a Taylor service technician to
correct rotation to clockwise from
operator end.
- - -
d. The circuit breaker is off or the fuse
is blown.
d. Turn the breaker on or replace the
fuse.
- - -
e. There is inadequate mix in the mix
hopper.
e. Fill the mix hopper with mix.
6-10
2. The product is too stiff. a. The viscosity needs adjustment. a. Contact a Taylor service technician. - - -
3. The product is too soft. a. Viscosity needs adjustment. a. Contact a Taylor service technician. - - -
b. Not enough airspace around
machine. (Air-cooled machines)
b. Allow for adequate airflow across the
condenser.
3-3
c. Worn scraper blades. c. Replace regularly. 9-1
d. Dirty condenser. (Air-cooled
machines)
d. Clean monthly.
7-1
e. Mix is out of date. e. Use only fresh mix. - - -
f. Loss of water. 
(Water-cooled machines)
f. Locate cause of water loss and
correct.
7-1
4. The mix in the mix
hopper is too cold.
a. The temperature is out of
adjustment.
a. Call a Taylor service technician to
adjust the mix hopper temperature.
- - -
5. The mix in the mix
hopper is too warm.
a. The temperature is out of
adjustment.
a. Call a Taylor service technician to
adjust the mix hopper temperature.
- - -
b. The mix hopper cover is not in
position.
b. Place the cover in position.
6-10
c. The MIX REF light is not lit. c. Press the MIX REF key. 5-2
6. The driveshaft is stuck in
the drive coupling.
a. Rounded corners of driveshaft,
coupling, or both.
a. Call a Taylor service technician to
correct the cause and to replace the
necessary components. Do not
lubricate the hex end of the
driveshaft.
- - -
b. Mix and lubricant collected in the
drive coupling.
b. Brush clean the rear shell bearing
area regularly.
6-11
7. The freezing cylinder
walls are scored.
a. The scraper blades are damaged. a. Replace the scraper blades. 6-2
b. Machine was placed in Auto mode
before all sanitizing solution was
removed from freezing cylinder.
b. Place machine in Auto mode only
after priming is complete and all
sanitizing solution is removed.
6-9
c. The front bearing is missing or
worn on the freezer door.
c. Install or replace the front bearing.
6-3
d. The beater assembly is bent. d. Call a Taylor service technician to
repair or replace the beater and
correct the cause of insufficient mix in
the freezing cylinder.
- - -

Taylor C706 Specifications

General

Brand	Taylor
Model	C706
Category	Freezer
Language	English