To Next Page

To Previous Page

Model C706 Operating Procedures

050126

Step 8

When a steady stream of sanitizing solution is flowing

from the prime plug opening in the bottom of the

freezer door, pull the draw handle down. Draw off all of

the sanitizing solution.

Figure 36

Step 9

Once the sanitizer stops flowing from the door spout,

raise the draw handle. Press the W ASH and PUMP

keys, cancelling the beater motor and pump operation.

Figure 37

Note: Be sure your hands are clean and sanitized

before continuing these instructions.

Step 10

Lubricate the mix feed tube o--rings located on the end

of the tube with the small hole on the side. Stand the

mix feed tube in the corner of the mix hopper . Place the

locking clip in position on the outlet fitting of the pump.

Figure 38

Priming

Step 1

Place an empty pail beneath the door spout and lower

the draw handle. Be sure the prime plug is still in the

UP position. Pour two gallons (7.6 liters) of fresh mix

into the hopper and allow it to flow into the freezing

cylinder. This will force out any remaining sanitizing

solution. When full strength mix is flowing from the

door spout, raise the draw handle.

Note: Use only FRESH mix when priming the

freezer .

Taylor C706 Original Operating Instructions

Other manuals for Taylor C706