1. Take the earphones out of the charging cradle. ( → C)
2. Do Steps 2 to 4 of “Connecting by pairing (registering) your earphones with a Bluetooth® device”.
• This unit remembers the device lastly connected. Connection may be automatically
established after step 1 (→ above).
E. Using the earphones
Listening to music
1. Connect the Bluetooth® device and the earphones. (→ D )
2. Select the music or video on the Bluetooth® device and start playback.
• The earphones will output the music or the audio of the video being played back.
List of operations available with the touch sensors
Switches between noise cancelling, ambient sound and off.
Noise cancelling: Reduces the sounds (noise) you can hear from outside. Ambient sound: You can hear
ambient sound through the microphones embedded in the earphones while enjoying music.
A beep sounds to indicate that you have touched to reach either the maximum or minimum volume level.
You can also use just one side of the earphones independently. In this case, it is only possible to perform
operations available on the side you are using.
Depending on the Bluetooth® device or the app, even if you operate the touch sensors on the earphones, some
functions may not respond or may operate differently from the descriptions above.
Restoring to the factory settings
Charge the earphones before restoring the earphones to their factory settings.
1. Take the R side earphone out of the charging cradle.
2. While the earphone LED lights (blue), touch and hold the touch sensor (R) for about 7 seconds.
• The earphone LED will light alternately in blue and red.
3. Touch and hold the touch sensor (R) for about 10 seconds.
• The earphone LED (blue) blinks rapidly, and when the power turns off, the earphone
returns to the factory settings.
4. Do the same Steps 1 to 3 above for the L side earphone.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
