Technics SC-CH700 User Manual

f Basic Operating Procedure
These functions can also be performed from the remote control.
Follow the procedure described below.
Hjola'a'al
ooooo
0^0 gog
OOCiloo'
taooaal
O C3 CD □ CDl
adoa
□ c
Tacdmics
J
1 Press the power “STANDBY (J) /ON” switch
to switch on the power.
2 Press the input select button to select the
desired sound source.
The display of the selected mode will appear.
TAPE: Press this button to listen to tapes (See page 34).
You can skip this step from the remote control.
CD: Press this button to listen to compact discs.
The compact disc or tape will automatically stop
when a different sound mode is selected during its
operation (See page 28).
TUNER: Press this button to listen to radio broadcasts (See
page 38).
» 3 Start the sound source.
; 4 Adjust the volume level,
t c
O Adjust the left-right volume balance.
Pressing the balance adjustment buttons simultaneously will
restore the balance to the center position.
•Perform fine balance adjustment while playing the selected
' music source. The balance display is only a rough quick.
After listening is finished
Be sure to reduce the volume level and switch the unit to the
standby mode using the power ‘'STANDBY(J)/ON” switch or the
“OFF/ON" switch on the remote control.
Note:
The sound source and equalizer settings will be retained (as they
were at the time when the power is switched to standby mode) by
the memory back-up function.
To temporarily reduce the volume
level
Press the muting button on the remote control.
MUTING
o
The muting indicator on the amplifier illuminates.
The volume level is attenuated by 20 dB (approx. Vio).
The muted state can be cancelled by pressing the muting button
once again or reduce the volume level by setting the volume level to
the “— dB" position.
24

Technics SC-CH700 Specifications

General

Brand	Technics
Model	SC-CH700
Category	Stereo System
Language	English