Technics SC-CH700 User Manual

Listening to Tapes (continued)
3 4 2 1
Listening to two tapes consecutively
Step 4 can be operated from the remote control. Follow the proce¬
dure described below.
1 L oad tapes in decks 1 and 2.
Be sure that the side that you wish to start to listen to is facing
you, and load it in deck 1.
I ftEMOTE I
►
Illuminates
2 P ress the reverse mode seiect button to set
the “ CPCP ’’ mode.
1 R6Mora 1
►
fo) Co)
.
...
c
50-
..............
n To) Co)
. . s s. y
Illuminates
3 P ress the Doiby noise reduction button to set
the Dolby NR mode B or C in which the tape
was recorded.
The Dolby noise reduction indicator (B or C) will illuminate.
If the tape was not recorded in a Dolby NR mode, press the
Dolby noise reduction button again and the Dolby NR indicator
will go out.
It is recommended that tapes in both decks are the same type
of the Dolby noise reduction.
4 P ress the deck 1 playback button to start play¬
back.
When operating from the remote control, first press the deck
1/2 selector on the remote control to Illuminate the deck 1
remote indicator.
r— i-REMgrri
PLAY^
' o ) ( o )
m
CO
►
(°) (o)
Deck 1 remote indicator will illuminate.
Two tapes will be played back as follows:
Forward \
rk side of tape y
1 in deck 1 /
Reverse \
side of tape y
in deck 1 /
Forward N.
side of tape y
in deck 2 y'
Reverse \
side of tape y—i
in deck 2 /
After repeating above operation 8 times, the tape will automatically
stop.
■ To stop the tape mid-way
This function can be operated from the remote control with the
procedure below.
Press the stop button of the deck in which the
tape is currently playing.
o I
•You can also start playback from a position other than the fonward
side of the tape in deck 1.
•If playback is started from deck 2, the tape in deck 1 will be played
back only seven times.

Technics SC-CH700 Specifications

General

Brand	Technics
Model	SC-CH700
Category	Stereo System
Language	English