Technics SC-CH700 User Manual

Tape-to-Tape Recording
The recording level of the original (playback) tape, and the noise
reduction effect on the original tape, will be recorded to the new
tape just as they were In the original recording.
435 2
hb
Tschnics
■ ■ ■
□ V
n
II
1 ' > iJ
^ ••nn. 1 nmiM
■
-
CZZJ CZ=)
—1—
fa
cd
,
COUHTfMWiWT OOuKM
1
□
To record from deck 1 to deck 2
It Is recommended that you use the editing tape of the same or
higher quality than the playback tape.
5 Press the synchro start button to start tape-
to-tape recording.
Have you switched on the power?
1 i nsert the piayback tape into deck 1 and the
editing tape into deck 2.
When deck 1 stops, the deck 2 automatically creates a non-
recorded passage of about 4 seconds in length, and then enters the
recording standby mode.
When deck 2 stops, deck 1 stops simultaneously.
2 Seiect the desired reverse mode.
*7^ : Single sided recording (forward side only)
Two sided recording
(forward side— ► reverse side)
In case the length of a tape set in deck 2 Is longer than
a tape In deck 1, deck 1 repeats the playback until deck
2 completes the two-sided recording, (up to eight
times)
CXP: Two sided recording
(forward side— ► reverse side)
3 When making a CCRT recording, press the
CCRT button to iiiuminate the CCRT indicator.
Illuminates
4 P ress the edit speed seiect button to seiect
the recording speed “X1” or “x2”.
X 1 : Select this mode when you wish to listen to the sound
while recording
x2; Select this mode when you wish to record with high¬
speed
While tape-to-tape recording is in progress, you can press one of
the input select buttons on the amplifier and enjoy listening to
another music source, such as a compact disc. You can change the
settings of the volume and tone controls of the sound processor
without affecting the recording.
■ To cancei the tape-to-tape recording
Press the stop button on deck 2.
□
Deck 1 will be also stopped.
When you press the stop button on deck 1 during tape-to-tape
recording, deck 2 will be entered the recording standby mode after
creating a non-recorded passage of about four seconds. To resume
the tape-to-tape recording, press the synchro start button.
Notes:
•Be sure to press the edit speed select button to go out the edit
speed indicator after finishing tape-to-tape recording.
•Switch off your television set or video equipment when performing
tape-to-tape recording at high speed (x2). The reason for this is
that noise is sometimes picked up and recorded.
52

Technics SC-CH700 Specifications

General

Brand	Technics
Model	SC-CH700
Category	Stereo System
Language	English