Technics SC-EH500 User Manual

Suggestions for safety
Placement
Avoid placing the unit in areas of:
• direct sunlight
•high temperature
• high humidity
•excessive vibration
•uneven surfaces (Place the unit on a flat level surface.)
Such conditions might damage the cabinet and/or other component
parts and thereby shorten the unit's service life.
To protect the unit against sound distortion and acoustical effects,
please place the unit at least 15 cm away from wall surfaces etc.
Stacking
Never place heavy items on top of the unit or the AC power cord.
Voltage
•It is very dangerous to use an AC power source of high voltage such
as for an air conditioner.
A fire might be caused by such a connection.
•A DC power source cannot be used.
Be sure to check the power source carefully, especially if on a ship
or other place where DC is used.
Power cord protection
•Avoid cuts, scratches or poor connection of the AC power cord, as
this may result in fire or electric shock.
Excessive bending, pulling or slicing of the cord should also be
avoided.
•Do not pull on the cord when you are disconnecting the power, as
this could cause an electric shock. Grasp the plug firmly when you
disconnect the power supply.
•Never touch the plug with wet hands or a serious electric shock
could result.
Foreign materials
•Ensure that no foreign objects, such as needles, coins, screwdrivers
etc., accidentally fall into the unit.
Otherwise, a serious electric shock or malfunction could occur.
• Be extremely careful about spilling water or liquid on/into the unit,
as a fire or electric shock could occur.
(Disconnect the power plug and contact your dealer immediately if
this occurs.)
•Avoid spraying insecticides onto the unit as they contain flammable
gases which can be ignited.
•Insecticides, alcohol, paint thinner and similar chemicals should
never be used to clean the unit as they can cause flaking or cloudi¬
ness to the cabinet finish.
•Never attempt to repair, disassemble or reconstruct the unit if there
seems to be a problem.
A serious electric shock could result if you ignore this precautionary
measure.
• If a problem occurs during operation (the sound is interrupted,
indicators fail to light up, smoke is detected, etc.) contact your
dealer or Authorized Service Center immediately.
• Disconnect the power supply if the unit will not be used for a long
time. Otherwise the operation life could be shortened.
For SC-EH600
Before moving or shipping this CD changer:
Prepare the CD changer as described below to prevent dam¬
age to the mechanism.
1. Remove ail CDs.
2. Select "CD" with INPUT SELECTOR on the tuner/ampli¬
fier.
3. Hold down stop button ( ■ ) on the changer for 5 seconds.
This will turn OFF the power and set the so-called "ship¬
ping mode".
4. Unplug the stereo.
Avoid strong vibrations or impact while moving the equip¬
ment. This shipping mode will be canceled automatically
when you turn the power ON the next time.

Technics SC-EH500 Specifications

General

Brand	Technics
Model	SC-EH500
Category	Speaker System
Language	English