Technics SC-HDA710 User Manual

35
RQT5479
Other operations
Fine adjustments to the treble range can be made due to separation
of the tweeter and woofer.
Turn [FINE TWEETER CONTROL].
Turn towards MAX to emphasize the treble or towards MIN to
lessen the effect.
The effect is not noticeable through headphones.
Note
Adjusting the treble range
Use this feature to emphasize the bass (HIGH or LOW), or weaken
it (LIGHT).
Press [BLFS].
Each time you press the button:
To cancel
Press [BLFS] to select “FLAT.”
BLFS HIGH BLFS LIGHTBLFS LOW
FLAT
Adjusting the bass –
BLFS (Brisk Low Frequency Sound)
Press [AUDIO ONLY].
The lamp lights.
The video signal is cut off.
AUDIO ONLY is canceled if the button is pressed again, the unit is
turned off or the disc tray is opened.
¡Video signals are output while the disc is stopped and when
operations such as skipping or searching are performed. The
television can appear unusual while video signals are not being
output.
¡Turn the television off for a better effect.
Note
To enjoy even higher quality sound -
AUDIO ONLY
Remote control only
Press [SHIFT] +
[BALANCE (L) or (R)] to
adjust the sound
balance.
To adjust left-right balance
Remote control only
Press [MUTING].
Volume is reduced to minimum.
To cancel
Press [MUTING] again. (“MUTING OFF” lights up.)
To cancel from the unit, turn [VOLUME] to minimum (- - dB), then
raise it to the required level.
Muting is also canceled when the unit is turned off.
Muting the volume
Remote control only
Press [DISP].
The display changes each time you press the button.
The information displayed depends on the source.
For example:
While playing DVD-Video
→ Time
↓
Graphic speaker channel display
↓
Spectrum analyzer
Refer to page 14 for information about the radio’s RDS displays.
To change the display
Reduce the volume before connection.
Avoid listening for prolonged periods of time to prevent hearing
damage.
Plug type: 3.5 mm stereo.
Using headphones (not included)
BLFS HIGH
BLFS
BALANCE
DVD-A DVD-V VCD
MUTING ON

Technics SC-HDA710 Specifications