Recording
Making a recording (Deck 2 only) ................................38
Recording from the radio or external source ................................ 38
Tape-to-tape recording ......................................................40
To record selected tracks ............................................................. 41
To cut unwanted parts during recording ....................................... 41
To erase recorded sound .................................................41
Adjusting the sound field and
sound quality
Enjoying sound with DOLBY PRO LOGIC ...............42
SURROUND ................................................................................ 42
3 STEREO ................................................................................... 42
Setting the center mode ............................................................... 42
Adjusting the output level of each speaker .................................. 43
Enjoying with SURROUND or 3 STEREO ................................... 44
Enjoying sound with SFC .................................................44
Using the graphic equalizer _......45
Adjusting the tone quality ............................................................. 45
Characteristics of each frequency range ...................................... 46
Examples of applications .......................................................... 46
Reference
Concerning compact discs .............................................47
Concerning cassette tapes ..............................................47
Maintenance ............................................................................48
Technical specifications ...................................................48
Troubleshooting guide ......................................................52
Product service .....................................................................54
Disc index ............................................................:...................55
CAUTION:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a cimuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/'rv technician for
help.
FCC Notice: This system complies with new Part 15, except for
the radio receiver, which complies with old Part 15, Subpart C of
the FCC Rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesirable operation. The radio
receiver is not subject to above item (2).
Any unauthorized changes or modifications to this equipment
would void the user's authority to operate this device.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
CAUTION
CAUTION:TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE SCREWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
_1 The lightning flash with arrowhead symbol, within
an equilateral trianglo, is intended to alert the user
to the presence of uninsulated "dangerous voltage"
within the product s enclosure that may be of suffi-
cient magnitude to constitute a dsk of electric shock
to persons.
j_IL Tbe exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the alP
pliance.
To Next Page
Loading...
Need help?
General
