English
(14)
14
Connecting to an integrated amplifier or component system
Connections and installation
z
Turn off all units and disconnect the AC power supply cord from the outlet before making any
connections.
z
Connect the AC power supply cord only after all other connections are completed.
z
Be sure to connect the PHONO earth lead. Otherwise mains hum may occur.
z
Refer also to the instruction manual of the connected device.
1
Connect the PHONO cables and
PHONO earth lead to the PHONO
terminals of the connected
equipment.
z
You will not have adequate volume or
sound quality if the connected amplifier
has no PHONO terminals.
2
Connect the AC power supply
cord.
z
Confirm the wattage of the AC outlet on
the connected equipment before using it
for this unit.
(This unit consumes 14 W.)
z
Although the AC power switch is in the "OFF" position, the unit is not completely disconnected
from the mains. Remove the plug from the main electrical outlet if you will not be using the unit for
an extended period of time. Place the unit so the plug can be easily removed.
Note
Amplifier (not included)
PHONOPHONO
EARTH
Back of main unit
5V 2.1APHONES
VOLUME
INPUT SELECTOR
LR
LR
Insert the AC power
supply cord up to a point
just before the round hole.
PHONO cable
PHONO earth lead
To a household
mains socket
SL-1200G_1210G PP北米_Black model add（GAEから再展開）_20210706-.indb 14SL-1200G_1210G PP北米_Black model add（GAEから再展開）_20210706-.indb 14 2021/07/15 9:17:332021/07/15 9:17:33
To Next Page
Loading...
Need help?
General