Technics SL-1210G User Manual

Getting started
English
(19)
19
Armlift height
Make an adjustment according to your
cartridge if necessary.
Preparation
z
Put a record on the turntable.
z
Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.
z
Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to the
step
2
.
z
The armlift height is factory-adjusted to
8 to 13 mm (
5
/
16
” to
33
/
64
”) .
You can choose manual mode or auto mode.
(Factory setting: Auto mode)


Auto mode
We recommend auto mode that can maximize
performance of the product. It adjusts the
"startup speed" (described below) automatically.
(The set torque control is not reflected.)

Move the mode switch to [A] using a tool
such as a thin screwdriver.


Manual mode
Allows you to adjust the "startup speed" manually.

Move the mode switch to [M] using a tool
such as a thin screwdriver.
Startup speed
You can adjust the startup speed (the time for
the turntable to reach the constant speed) from
pressing [START-STOP] and the torque gain at
the constant speed.

Adjust the torque knob using a flat
screwdriver.
z
H direction: Fast startup
z
L direction: Slow startup
Brake speed
You can adjust the brake speed from pressing
[START-STOP] until the turntable stops.
(Adjustment is possible in both auto and
manual mode.)

Adjust the brake speed control knob using a
flat screwdriver.
z
S direction: Slow stop
z
F direction: Fast stop
S
BRAKE
TORQUE
F
H
L
M
A
Brake speed
control knob
Torque knob
Mode switch
Adjusting the turntable startup/
brake speed
Note
z
Use a commercially available mini flat
screwdriver (2.4 mm [
3
/
32
” ] ) to adjust the
torque/brake speed control knob.
z
Do not turn the knob too far using an
excessive force.
19
2
Return the tone arm to the arm
rest, clamp it with the arm clamp
and while pressing the armlift
down with your finger, turn the
screw to adjust the height.
z
Turning the screw clockwise lowers the
armlift.
z
Turning the screw anti-clockwise raises
the armlift.
4
1
2
Armlift screw
Armlift
Arm clamp
SL-1200G_1210G PP北米_Black model add（GAEから再展開）_20210706-.indb 19SL-1200G_1210G PP北米_Black model add（GAEから再展開）_20210706-.indb 19 2021/07/15 9:17:342021/07/15 9:17:34

Technics SL-1210G Specifications

General

Brand	Technics
Model	SL-1210G
Category	Turntable
Language	English