Notice
All procedures, data, information, drawings, specifications or other material, whether accompanying this document or separately
supplied in furtherance of this document, contain confidential and proprietary information which (i) is the property of TechnipFMC plc,
(ii) i
s disclosed by TechnipFMC only in confidence, and (iii) except as TechnipFMC may otherwise permit in writing, is to be used,
disclosed or copied only to the extent necessary for the evaluation and use thereof by the recipient.
The foregoing shall not apply to any such material to the extent that the contents (i) are now or subsequently become available to the
public without payment, (ii) were previously known to the recipient, or (iii) subsequently become otherwise known to the recipient
without restriction.
This document is based on information available at the time of its publication. While efforts have been made to be accurate, the
information contained herein does not purport to cover all details or variations in hardware and software, nor to provide for every
possible contingency in connection with installation, operation and maintenance.
TechnipFMC makes no representation or warranty, either expressed or implied, with respect to, and assumes no responsibility for, the
accuracy, completeness, or sufficiency of the information contained herein. No warranties of merchantability or fitness for a particular
purpose shall apply.
Smith Meter is a registered trademark. The TechnipFMC logo is a trademark.
This document takes precedence over and supersedes in their entirety all previous versions or revisions.
Bulletin MN06201 Issue/Rev 0.2 (3/21)
Copyright © 2021 TechnipFMC plc. All rights reserved.
USA Operation
1602 Wagner Avenue
Erie, Pennsylvania 16510 USA
+1 814.898.5000
TechnipFMC.com
TechnipFMC Headquarters
13460 Lockwood Road
Building S01
Houston, Texas 77044 USA
+1 281.591.4000
Germany Operation
Smither Meter GmbH
Regentstrasse 1
2574 Ellerbek, Germany
+49 4101 304.0
To Previous Page
Loading...
Need help?
General
