Installation Introductions
10
016-1674-50 Rackmount Kit
If the bracket is attached with two instrument, omit the following procedure for
attaching panel.
1. Put the panel next to the instrument as in the Figure 5 and align the panel
screw holes with the bracket screw holes.
2. Attach the panel to the bracket with two screws (M3 6 mm) using a #2
phillips tip screwdriver.
3. Set the instrument attached to the bracket with the bottom down on the work
surface and the front facing you.
4. Attach the panel to the instrument with one screw (M4 5 mm) using a #2
phillips tip screwdriver. See Figure 7.
5. Install one screw (M3 6 mm) from the right side of the bracket to fix the
panel using a #2 phillips tip screwdriver.
M4X5mm
M3X6mm
Screw
Screw
Figure 7: Attaching panel
Attaching Panel
To Next Page
Loading...
Need help?
General
