Preface
If you have data security concerns, this document helps you to sanitize or remove
memory devices from the DPO2000/B and MSO2000/B Series Digital Phosphor
and Mixed Sig
nal Oscilloscopes.
The DPO2000/B a nd MSO2000/B series products have data storage (memory)
devices and
data output devices (USB ports). These instructions tell you how
to clear or sanitize the memory devices, and also tell you how to declassify an
instrument that is not functioning.
Instrument code and calibration settings reside in nonvolatile flash memory.
Instrument setups and reference waveforms may also be stored in flashmemoryor
on USB drives connected to the instrument.
If you have any questions, contact the Tektronix Technical Support Center at
www.tektronix.com/support.
Products
The following Tektronix products are covered by this document:
DPO20
02B
DPO2004B
DPO2012/B
DPO2014/B
DPO2022B
DPO2024/B
MS
O2002B
MSO2004B
MSO2012/B
MSO2014/B
MSO2022B
MSO2024/B
Related Documents
The DPO2000 and MSO2000 Series Digital Phosphor and Mixed Signal
Oscilloscopes Service Manual, part number 071-2331-XX, is available on the
Tektronix Web site at www.tektronix.com/manuals.
DPO2000/B and MSO2000/B Series Declassification a nd Security Instructions iii
To Next Page
Loading...
Need help?
General
