Tektronix DPO2012 Programmer's Manual

Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
WFMOutpre:NR_Pt?
Related Commands
CURVe, DATa, DATa:STARt, DATa:STOP, SAVe:WAVEform,
SAVe:WAVEform:FILEFormat, WFMInpre:NR_Pt
Exampl
es
WFMOUTPRE:NR_PT? might return :WFMOUTPRE:NR_PT 10000 indicating that
there are 10000 data points to be sent.
WFMOutpre:PT_Fmt? (Query Only)
Retu
rns the point format for the outgoing waveform specified by the DATa:SOUrce
command. Returned values are either ENV, which indicates envelope mode
format in which the data is returned as a series of min/max pairs, or Y, which
indicates normal waveform points. The query command will time out and an error
will be generated if the waveform specified by DATa:SOUrce is not turned on.
Group
Waveform Transfer
Syntax
WFMOutpre:PT_Fmt?
Related Commands
CURVe, DATa:SOUrce
Examples
WFMOUTPRE:PT_FMT? might return :WFMOutp re:PT_Fmt ENV indicating that
the waveform data is a series of min-max pairs.
WFMOutpre:PT_Off? (Query Only)
The set form of this command is ignored. The query form always returns a 0, if
the waveform specified by DATA:SOUrce is on or displayed. If the waveform
is not displayed, the query form generates an error and returns event code 2244.
This command is for compatibility with other Tektronix oscilloscopes.
Group
Waveform Transfer
Syntax
WFMOutpre:PT_Off?
2-368 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix DPO2012 Specifications

General

Brand	Tektronix
Model	DPO2012
Category	Test Equipment
Language	English