Tektronix DPO2012B Programmer's Manual

Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
DATa:STARt <NR1>
DATa:STARt?
Related Commands
CURVe, DATa, DATa:STOP, WFMInpre:NR_Pt, WFMOutpre:NR_Pt?
Arguments
<NR1> is the first data point that will be transferred, which ranges from 1 to the
record length. Data will be transferred from
<NR1> to DATa:STOP or th
erecord
length, whichever is le ss. If
<NR1> is greater than the record length, the last
data point in the record is transferred.
DATa:STARt and DATa:STOP are order independent. When DATa:STOP is
greater than DATa:STARt, the values will be swapped internally for the CURVE?
query.
Examples
DATA:START? might return :DATA:ST ART 214 indicating that data p oint 214 is
the first waveform data point that will be transferred.
DATA:START 10 specifies that the waveform transfer will begin with data point 10.
DATa:STOP
Sets or returns the last data point that will be transferred when using the CURVe?
query. This command allows for the transfer of partial waveforms from the
oscilloscope.
Changes to the record length value are not automatically reflectedinthe
DATa:STOP value. As record length is varied, the DATa:STOP value must be
explicitly changed to ensure the entire record is transmitted. In other words, curve
results will not automatically and correctly reflect increases in record length if
the d istance from DATa:STARt to
DATa:STOP stays smaller than the increased
record length.
Group
Waveform Transfer
Syntax
DATa:STOP <NR1>
DATa:STOP?
Related Commands
CURVe, DATa, DATa:STARt, WFMInpre:NR_Pt, WFMOutpre:NR_Pt?
2-132 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix DPO2012B Specifications

General

Brand	Tektronix
Model	DPO2012B
Category	Test Equipment
Language	English