Tektronix DPO2012B Programmer's Manual

Command Groups
Table 2-26: Measurement Commands (cont.)
Command
Description
MEASUrement:IMMed:DELay? Returns information about the immediate
delay measurement
MEASUrement:IMMed:DELay:DIRection Sets or returns the search direction to use for
immediate delay measurements
MEASUrement:IMMed:DELay:EDGE<x> Sets or returns the s lope of the edge used for
immediate delay “from” and “to” waveform
measurements
MEASUrement:IMMed:SO Urce1 Sets or returns the “from” source for all single
channel immediate measurements
MEASUrement:IMMed:SO Urce2 Sets or returns the source to measure “to” for
phase or delay immediate measurements
MEASUrement:IMMed:TYPe Sets or returns the type of the immediate
measurement
MEASUrement:IMMed:UN Its? Returns the units of the immediate
measurement
MEASUrement:IMMed:VALue? Returns the value of the immediate
measurement
MEASUrement:INDICa tors?
Returns all measurement indicator
parameters
MEASUrement:INDICa tors:H OR Z <x> ? Returns the position of the specified
horizontal measurement indicator
MEASUrement:INDIC ators:N UMHORZ? Returns the number of horizontal
measurement indicators currently being
displayed
MEASUrement:INDICators:NUMVERT? Returns the number of vertical measurement
indicators currently being displayed
MEASUrement:INDIC ators:STATE Sets or returns the state of visible
measurement indicators
MEASUrement:INDICators:VERT<x>? Returns the value of the specified vertical
measurement indicator
MEASUrement:MEAS<x>?
Returns all measurement parameters
MEASUrement:MEAS<x>:COUNt? Returns the number of values accumulated
since the last statistical reset
MEASUrement:MEAS<x>:DELay?
Returns the delay measurement parameters
for the specified measurement
MEASUrement:MEAS<x>:DELay:DIRection Sets or returns the search direction to use for
delay measurements
MEASUrement:MEAS<x>:DELay:EDGE<x> Sets or returns the slope of the edge to
use for delay “from” and “to” waveform
measurements
MEASUrement:MEAS<x>:MAXimum? Returns the maximum value found since the
last statistical reset
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-27

Tektronix DPO2012B Specifications

General

Brand	Tektronix
Model	DPO2012B
Category	Test Equipment
Language	English