Power-On and Power-Off Procedure
Functional Ch
eck
Perform this quick functional check to verify that your oscilloscope is operating
correctly.
1. Connect the oscilloscope power cable as described in Powering On the
Oscilloscope. (See page 18, Power-On and Power-Off Procedure.)
2. Power on the oscilloscope.
3. Connect the proper TPP0100 or TPP0200 probe tip and reference lead to the
PROBE COMP connectors on the oscilloscope.
4. Pu
sh Default Setup.
MSO2000B and DPO2000B Installation and Safety Instructions 19
To Next Page
Loading...
Need help?
General
