Power-On and Power-Off Procedure
Upgrading Firmware
To upgrade the firmware of the oscilloscope:
1. Open up a Web browser and go to www.tektronix.com/software. Proceed to
the software finder. Download the latest firmware for your o scilloscope on
your PC.
Unzip the files and copy the firmware.img file into the root folder of a USB
flash drive.
2. Power o ff your oscilloscope.
3. Insert the USB flash drive into the front-panel USB port on your oscilloscope.
4. Power on the oscilloscope. The oscilloscop
e automatically recognizes and
installs the replacement firmware.
If the oscilloscope does not install the firmware, rerun the procedure. If
the problem continues, try a different model of USB flash drive. Finally, if
needed, contact qualified service personnel.
NOTE. Do not p ower off the oscilloscope or remove the USB flash drive until the
oscillo
scope fi nishes installing the firmware.
5. Power off the oscilloscope and remove the USB flash drive.
6. Power on the oscilloscope.
7. Push Utility.
8. Push Utility Page.
9. Turn multipurpose knob a and select Config.
10. Push About. The oscilloscope displays the firmware version number.
11. Confirm that the version number matches that of the new firmware.
NOTE. For more information on updating the firmware, refer to the electronic
(PDF) MSO/DPO2000B User Manual.
22 MSO2000B and DPO2000B Installation and Safety Instructions
To Next Page
Loading...
Need help?
General
