3: Using a remote interface Model DMM7510 7½ Digit Multimeter
3-2 DMM7510-900-01 Rev. C / September 2019
The rear-panel connections for the remote communication interfaces are shown in the
following figure.
Figure 13: DMM7510 remote interface connections
GPIB communications
The DMM7510 GPIB interface is IEEE Std 488.1 compliant and supports IEEE Std 488.2 common
commands and status model topology.
You can have up to 15 devices connected to a GPIB interface, including the controller. The maximum
cable length is the lesser of either:
• The number of devices multiplied by 2 m (6.5 ft)
• 20 m (65.6 ft)
You may see erratic bus operation if you ignore these limits.
Install the GPIB driver software
Check the documentation for your GPIB controller for information about where to acquire drivers.
Keithley Instruments also recommends that you check the website of the GPIB controller for the latest
version of drivers or software.
It is important that you install the drivers before you connect the hardware. This prevents associating
the incorrect driver to the hardware.
To Next Page
Loading...
Need help?
General
