Use the MDO3SEC option to enable the IO ports
If your instrument has the MDO3SEC option installed, use the following
procedure to turn on all of the I/O ports.
1. Push the front-panel Utility button.
2. Push the Utility Page lower-bezel button and use the Multipurpose a knob
to select Security.
3. Push the Security Password lower-bezel button.
4. Use the Multipurpose knob to enter a password.
5. Push the I/O Ports lower-bezel button.
To disable all USB and Ethernet ports on the oscilloscope, push the OK
Enable All Ports on the side-bezel button.
6. Push the Menu Off front-panel button to close the dialog box.
7. Power off the oscilloscope, and then power it back on to complete the
process.
Enable the LAN port and set the LAN Ethernet settings
To Enable the LAN port and set the LAN Ethernet settings, such as IP addresses,
complete the steps in this procedure.
1. Push the front panel Default Setup button.
2. Push the front-panel Utility button.
3. Push the Utility Page lower-bezel button and use the Multipurpose a knob
to select I/O.
4. Push the Network Configuration lower bezel button.
5. Push the Manual side bezel button. Wait for this operation to complete.
6. Push the Set IP Address Manually side bezel button.
7. Push the ↑ or ↓ arrow side-bezel button to position the cursor on the
Instrument IP Address field.
8. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
9. Push the ↓ arrow side-bezel button to position the cursor on the Gateway IP
Address field.
10. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
11. Push the ↓ arrow side-bezel button to position the cursor on the Subnet
Mask field.
12. Enter the relevant field data using the lower bezel buttons and Multipurpose
a knob.
Clear and sanitize procedures
10 MDO3000 Series Declassification and Security Instructions
To Next Page
Loading...
Need help?
General
