Preface
This document helps customers with data security concerns to sanitize or remove
memory devices from the Tektronix MDO3000 Series Mixed Domain
Oscilloscopes.
These products have data storage (memory) devices and data output devices.
These instructions tell how to clear or sanitize the memory devices and disable
the data output devices. The instructions also tell how to declassify an instrument
that is not functioning.
Instrument code and calibration settings reside in nonvolatile flash memory.
Instrument setups and reference waveforms may also be stored in flash memory
or on USB drives connected to the instrument.
If you have any questions, contact the Tektronix Technical Support Center at
www.tektronix.com/support.
Reference
The procedures in this document are written to meet the requirements specified
in:
■
NISPOM, DoD 5220.22–M, Chapter 8
■
ISFO Process Manual for Certification & Accreditation of Classified Systems
under NISPOM
Products
The following Tektronix products are covered by this document:
■
MDO3012
■
MDO3014
■
MDO3022
■
MDO3024
■
MDO3032
■
MDO3034
■
MDO3052
■
MDO3054
■
MDO3102
■
MDO3104
Required documents
To perform the procedures in this document, you might need access to the
MDO3000 series manuals listed below. These manuals are available on the
Tektronix Web site at www.tektronix.com/downloads.
■
MDO3000 Series Service Manual (Tektronix part number, 077-0981-xx)
■
MDO3000 Series Technical Reference Manual (Tektronix part number,
077-0979-xx)
MDO3000 Series Declassification and Security Instructions iii
To Next Page
Loading...
Need help?
General
