Tektronix MSO5104B User Manual

Compliance info
rmation
Compliance in
formation
This section lists the EMC (electromagnetic compliance), safety, and environmental standards with which the instrument
complies.
EMC compliance
EC Declaration of Conformity – EMC
Meets intent of Directive 2004/108/EC for Electromagnetic Compatibility. Compliance was demonstrated to the following
specifications as listed in the Official Journal of the European Communities:
EN 61326-1:2006, EN 61326-2-1:2006. EMC r equirements for electrical equipment for measurement, control, and
laboratory use.
123
CISPR 11:2003. Radiated and conducted emissions, Group 1, Class A
IEC 61000-4-2:2001. Electrostatic discharge immunity
IEC 61000-4-3:2002. RF electromagnetic field immunity
4
IEC 61000-4-4:2004. Electrical fa st transient/burst immunity
IEC 61000-4-5:2001. Power line surge immunity
IEC 61000-4-6:2003. Conducted RF immunity
4
IEC 61000-4-11:2004. Voltage dips and interruptions immunity
EN 61000-3-2:2006. AC power line harmonic emissions
EN 61000-3-3:1995.
Voltage changes, fluctuations, and flicker
European contact.
Tektronix UK, Ltd.
Western Peninsula
Western Road
Bracknell, RG12 1RF
United Kingdom
1
This product is intended for use in nonresidential areas only. Use in residential areas may cause electromagnetic int
erference.
2
Emissions which exceed the levels required by this standard may occur when this equipment is connected to a test object.
3
If interconnect cables are used, they must be low–EMI shielded cables such as the following Tektronix part numbers or their
equivalents: 012-0991-01, 012-0991-02 or 012-0991-03 GPIB Cable; 012-1213-00 (or CA part number 0294-9) RS-232 Cable;
012-1214–00 Centronics Cable; or LCOM part number CTL3VGAMM-5 V GA Cable. Use an 012-0482-00 cable for the Ref O ut connector.
4
The performance criterion for when the oscilloscope is subjected to the continuously present electromagnetic phenomenon:
MSO70000C/DX, DPO70000C/DX, and DPO7000: 10 mV/division to 1 V/division: ≤0.4 division waveform displacement or
≤0.8 division increase in peak–to–peak noise. MSO5000B and DPO5000B: ≤4.0 division waveform displacement or ≤8.0 division
increase in peak–to–peak noise.
Australia / New Zealand Declaration of Confo rmity – EMC
Complies with the EMC provision of the Radiocommunications Act per the following standard, in accordance w ith ACMA:
MSO/DPO70000DX, MSO/DPO70000C, DP O7000C, and MS O/DPO5000B Series User Manual ix

Tektronix MSO5104B Specifications

General

Brand	Tektronix
Model	MSO5104B
Category	Test Equipment
Language	English