Removal and installation procedures
Equipment requ
ired. Most modules in the instrument can be removed with a
size T15 TORX screwdriver. Other tools needed for complete disassembly are
listed in the following table.
Table 3-3: Tools required for module removal
Item no. Name Description General tool number
1
Screwdriver handle Accepts TORX-driver
bits
620-440
2
T10 TORX tip Used for removing
instrument. screws
TORX-driver bit for
T10 size screw heads
640-235
3
T15 TORX tip Used for removing most
instrument screws.
TORX-driver bit for
T15 size screw heads
640-247
4
1/8 inch flat-bladed
screwdriver
Screwdriver for
unlocking cable
connectors
Standard tool
5
#0 Phillips screwdriver Screwdriver for
removing small philli ps
screws, CDRW, and
hard drive
Standard tool
6 Angle-tip Tweezers
Used to remove front
panel knobs
Standard tool
7
3/16 inch open-end
wrench
Used to remove nut
posts
Standard tool
8
5/16 inch open-end
wrench
Used to remove nut
posts
Standard tool
9
MA-800G Soldering Aid
Used to remove the
front panel trim
Standard tool
3–8 RSA5100B Series Service Manual
To Next Page
Loading...
Need help?
General
