TPP0101 a nd TPP0201 Series 10X Passive Probes Information
Table 5: Certifications and compliances, (cont.)
Characteristics Description
Category Examples of Products in this Category
CAT III Distribution-level mains, fixed installation
CAT II
Local-level mains, appliances, portable equipment
Measurement
Category
Descriptions
CAT I Circuits not directly connected to mains.
Pollution Degree 2 Do not operate in environments where cond–
uctive pollutants may be present (as defined in IEC 61010-1). Rated
for indoor use only.
Equipment Recycling. This product complies with the European Union’s
requirements according to D irective 2002/96/EC on waste electrical and
elec
tronic equipment (WEEE). For more information about recycling options,
check the Support/Service section of the Tektronix Web site (www.tektronix.com).
Safe
ty Summary
Review the following safety precautions to avoid injury and prevent d amage to
this product or any products connected to it. To avoid potential hazards, use this
pr
oduct only as specified. Using the probe or accessories in a manner not specified
couldresultinashockorfire hazard.
To Avoid Fire or Personal
In
jury
Ground-Referenced Oscilloscope Use. Do not float the reference lead of this
probe when using with ground referenced oscilloscopes (for example, TBS series
oscilloscopes). The reference lead must be connected to earth potential (0 V).
Connect and Disconnect Properly. Connect the probe output to the measurement
instrument before connecting the probe to the circuit under test. Disconnect
the probe input and the probe reference lead from the circuit under t
est before
disconnecting the probe from the measurement instrument.
Avoid Electric Shock. Do not connect or disconnect probes or test leads while
they are connected to a voltage source.
Observe All Terminal Ratings. To avoid fire or shock hazard, observe all ratings
and markings on the product. Consult the product manual for further ratings
information before making connections to the product.
Avoid Electric Shock. When using probe accessories, never exceed the lowest
rating of the probe or its accessory, whichever is less, including the measurement
category and voltage rating.
Inspect the Probe and Accessories. Before each use, inspect the probe and
accessories for damage (cuts, tears, defects in the probe body, accessories, cable
jacket, etc.). Do not use if damaged.
34 TBS1000 Series Oscilloscopes Installation and Safety Manual
To Next Page
Loading...
Need help?
General
