Reference
3Ć130
Saving and Recalling Setups
You may want to save and reuse setups for many reasons. For example, after
changing the setting during the course of an experiment, you may want to
quickly return to your original setup. You can save and recall up to ten instru-
ment setups from internal oscilloscope memory. The information is retained
even when you turn the oscilloscope off or unplug it.
To save the current setup of the digitizing oscilloscope:
1. Press SETUP ➞ Save Current Setup (main).
Before doing step 2 that follows, note that if you choose a setup
location labeled
user
, you will overwrite the user setup previously
stored there. You can store setups in setup locations labeled
factory
without disturbing previously stored setups.
2. To store to a setup internally, choose one of the ten internal storage
locations from the side menu To Setup 1, To Setup 2, ... (see Fig-
ure 3-68). Now the current setup is stored in that location.
Figure 3-68: Save/Recall Setup Menu
Operation
To Next Page
Loading...
Need help?
General
