Example 4: Saving Setups
Getting Started
1Ć24
Figure 1-20: Save/Recall Setup Menu
7. Press one of the To Setup side menu buttons to store the current instru-
ment settings into that setup location. Remember which setup location
you selected for use later.
There are more setup locations than can be listed at one time in the side
menu. The –more– side menu item gives you access to all the setup
locations.
Once you have saved a particular setup, you can change the settings as
you wish, knowing that you can come back to that setup at any time.
8. Press MEASURE ➞ Positive Width (side) to add that measurement to
the display.
To recall the setup, Press SETUP ➞ Recall Saved Setup (main) ➞ Recall
Setup (side) for the setup location you used in the last exercise. The positive
width measurement is now removed from the display because you selected it
after you saved the setup.
This completes the tutorial. You can restore the default settings by pressing
SETUP ➞ Recall Factory Setup (main) ➞ OK Confirm Factory Init (side).
Recalling a Setup
To Next Page
Loading...
Need help?
General
