Tektronix TDS2024B User Manual

TDS1000B and TDS2000B Series Oscilloscope Service Manual
5-- 1
Adjustment Procedures
This chapter contains adjustment procedures for the TDS1000B and TDS2000B
series oscilloscopes.
Only qualified personnel should perform service procedures. Read the Service
Safety Summary and the General Safety Summary at the beginning of this manual
before performing any service procedures. Also refer to the user manual for
information about using the TDS1000B and TDS2000B oscilloscopes.
NOTE. The voltage references inside the TDS1000B and TDS2000B oscilloscopes
are very stable over time and should not require routine updates. Before
performing any procedure in this chapter, first verify that the oscilloscope does
not meet specifications. Refer to the chapter Performance Verification to verify
the specifications.
Required Equipment
The equipment described in Table 5--1, or a suitable equivalent, is required to
complete these procedures.
Table 5--1: Required equipment
Description Minimum requirements Examples
DC Voltage Source -- 2 0 V t o 2 0 V, ±0.1% accuracy Wavetek 9100 Universal Calibration
System with Oscilloscope
Calibration Module (Option 250)
Leveled Sinewave
Generator
5 kHz and 200 MHz, ±0.6%
amplitude accuracy
Fluke 5500A Multi-product
Calibrator with Oscilloscope
Calibration Option
(Option 5500A-SC)
50 Ω BNC Cable
BNCmaletoBNCmale,
≈ 1 m (36 in) long
Tektronix part number 012-0482-XX
50 Ω BNC Cable (seven)
BNCmaletoBNCmale,
≈ 25 cm (10 in) long
Tektronix part number 012-0208-XX
50 Ω Feedthrough
Termination
BNC male and female
connectors
Tektronix part number 011-0049-XX

Tektronix TDS2024B Specifications

General

Brand	Tektronix
Model	TDS2024B
Category	Test Equipment
Language	English