Reference
Push the G ated By Screen button to Select the Z (gate) Source Channel.
The general purpose knob sets the Z -ch annel threshold level. Z-channel
signals above the set threshold are true and open the XY signal gate;
Z-channel signals below the set threshold are false and close the XY
signal gate. The gating channel is always a high-true logic; to emulate
a low-true gating logic, use the Vertical menu to invert the Z-chann el
signal.
XY and XYZ Cursors. (See page 74, XY Cursor Menu.)
Hard Copy
Push the hard co py button at the lef t of the display to make a hard copy.
You can also store hard
-copyimagesonaUSBflash drive (in normal or
compressed format) and then transfer them later to a PC for printing o r
use i n a report.
Connecting a Print
er
Use the rear-panel R S-232 (av a ilab le on the optional communication
module), or Ether
net port to c on nect your oscilloscope to a prin ter.
Setting U p to Print
To set up the os
cilloscope to print a hard copy, follow these steps:
1. Push the Utility menu button .
2. Push the System bottom button to select Hard Copy.
3. Push the Fo
rmat screen button and then choose the printer format
appropriate for your application.
4. Push the O
ptions screen button to select the im age orientation
(portrait or landscape) as well as turn on or off hard copy file
compression.
5. Push the Ink Saver screen button and select On for most
applications. If you want the hard copy colors to be the same as
the scr
een colors, you can select Off.(Seepage80,Ink Saver
and Preview.)
78 TDS3000C Series Oscilloscope User Manual
To Next Page
Loading...
Need help?
General
