Teldat RS123w-4G User Manual

3.6 Connecting the data
The RS123 has the following data connections.
3.6.1 4-port Ethernet switch
The RS123 incorporates a 4-port 10/100/1000 BaseT switch with automatic MDI/MDIX to connect to a local area net-
work (LAN).
Please pay careful attention to the labeling so you do not confuse this switch with other types of ports:
Fig. 10: LAN switch PORTs
Note
The only connector available during booting and in BIOS mode is the ETH 1 connector.
3.6.2 WAN connection
The RS123 incorporates an Ethernet interface for WAN connection. This port has 2 connectors: SFP for optical link
and RJ45 for 10/100/1000 Base-T link. However, they cannot work simultaneously.
Note
The SFP connector is enabled by purchasing a license. This connector is disabled by default.
This interface is totally independent from the switch and is treated as just another interface.
Please pay careful attention to the labeling to avoid confusing these ports with other port types:
Fig. 11: WAN PORT
Note
The WAN connector does not work during booting and in BIOS mode.
3.6.2.1 SFP connector
Note
The SFP connector is enabled by purchasing a license. It is disabled by default.
The main characteristics of this port are as follows:
Teldat S.A.
3 Components and Power Supply
RS123 Router 13

Teldat RS123w-4G Specifications

General

Brand	Teldat
Model	RS123w-4G
Category	Network Router
Language	English