The EC declaration of conformity and additional product documentation can be accessed here:
http://www.teldat.com
4.6 CE marking
This equipment is in conformity with CE procedures and marking.
4.7 National restrictions
In accordance with Article 10 of 2014/53/EU, we inform you that national restrictions and requirements may apply
when it comes to authorization. These can change with time. Teldat S.A. recommends that you check with local au-
thorities for the latest status of their national regulations.
This product is supplied with antennas in order to fulfill local regulations. Do not choose other antennas. To comply
with power limits and RF exposure requirements, the antennas used for this transmitter must be installed in such a
way that they are always separated from nearby persons by a minimum distance of, at least, 25 cm.
4.8 FCC statements
4.8.1 Interference
The model TLDPR04A1 contains FCC ID: XMR201805EC25AU and FCC ID: YUAWMCND03TD
This equipment model TLDPR04A1 has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in-
terference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following means:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including in-
terference that may cause undesired operation.
This device is restricted to indoor use.
4.8.2 Radiation exposure
This equipment complies with the FCC radiation exposure limits specified for an uncontrolled environment. During in-
stallation and operation, keep a minimum distance of 20cm between the radiating equipment and your body.
4 Compliance Teldat S.A.
22 RS123 Router
To Next Page
Loading...
Need help?
General
