60 www.behnke-online.de
GB
Instructions SIP intercoms series 20-0001BS, 20-0014BS, 20-0016BS
Mounting
“Click”
Electronics box
Module housing
cover
Module housing
2
Unpack and disassemble basic electronics
20-0001-BS, 20-0014-BS, 20-0016-BS. Immedi-
ately upon receipt, check that all required parts
(instructions, name tag inserts) are present.
For further mounting of your intercom stations,
the electronics box must be separated from
the module housing. To do this, proceed as
described below. Be sure to observe the sketch
when doing so.
Carefully lever the electronics box out of the
module housing using a suitable screwdriver
and place it on a suitable surface. Do not open
the electronics box. Loosen the cover of the
module housing by hand and place it on a suit-
able surface. For basic electronics 20-0014-BS,
there is no need for the module housing cover.
!
Do not loosen the 4 screws ( ) of the
electronics box! Do not open the electron-
ics box. The device can be destroyed!
To Next Page
Loading...
Need help?
General
