A"
TEMPTRONlC
TP04
100A
Operator's Manual
Rev
B:
04/15/98
CORPORATION
To execute a function press the corresponding Program Button.
The function selections at the bottom of the display screen in Figure 6-1 are summarized as
follows.
Note:
Default
'Ow
Test Setup:
any changes made to any active setpoint temperature or system
parameter value are stored in this default
"0"
Test Setup program. All values in Test Setup
program
"0"
are replaced by the new values fkom any of the Test Setup programs (1 through
9)
when one of them is selected to
run.
When the system is initially turned on, Test Setup program
"0"
is the default program used for system operation. To copy the default
"0"
Test Setup into
another setup, see "Copy Test Setups" in the
TP041
OOA
Interface
&
Applications Manual.
Page:
24
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com